This little girls' vintage petticoat design from the 50s era is perfect for dolls. I love the flat front panel and gathered side skirts. Without much more effort than a regular gathered skirt petticoat you can create this beautiful petticoat with stand out design features.
You can also make it without the ruffle. Just extend the hemline.
If you intend to sew this one I have written up some details that may be helpful.
Batiste
The best fabric for underwear is batiste. It is a moderately lose weave fabric that has a nice crisp feel to it. The slight stiffness is perfect for holding out dress skirts.
Polycotton
Another fabric I used was polycotton. This closely woven fabric is a bit softer and thinner than quilters 100% cotton and still fits under the dresses I make using my 1804 pattern.
I have started putting a 3/4" facing allowance on my designs so you can easily finish the egde as you please. I have done a single fold hem on this one.
Synthetic Lining
I had some synthetic lining fabric that I thought might be good. It is thin yet still has some body to it. Unfortunately it tends to fray easily and makes a fluffy ball of threads in seconds if you handle it a lot like when you are gathering the ruffle.
If I was to use this fabric again I would overlock the edge and pull up the overlocker thread to gather. You can see where the trim is that it is starting to fray.
I also tried zig zagging over a thin cord but found that the edge got messy as I stitched and I had to move further in than the 1/4" seam allowance. So if you want to zig zag over cord to gather the ruffle for this fabric you will need a wider seam allowance.
Adding trim to the ruffle
Because the ruffle edge is straight you will need to finish the edge to stop it fraying either before you sew on the trim or as you sew on the trim.
Some flat laces could be overlocked on. For other trims it is best to use pinking shears and just shave off the very edge so you don't reduce the seam allowance.
Trim at the neck and arm holes
The stretchiness of the gathered lace trim allowed the hem to turn smoothly. However, whenI used the rick rack I had to put a few snips at the tightest section of the curves to help it lie flat.
The raw edge on the garment and the snipping is not a problem because the curved edges of the neck and arm holes resist fraying.
The rick rack I used measures 1/4" from the crest to the trough so it just fits nicely on my 1/4" seam allowance leaving the little bumps to show when I turn it in.
Length
The length of my pattern finishes about 1/2" above the just on the knee skirt length for dresses I make with my 1804 pattern.
I haven't tried making it shorter or longer but my educated suggestion is that to make it longer you should lengthen the body section by just adding to the bottom edge. You will then have to lengthen the side skirt pattern piece by the same amount. Just make sure you lengthen the hem edge not the side edge. I have labelled the waist edge and the side edge on the pattern pieces.
Fit and resizing
Vintage AGD: I have found that this petticoat fits my plumper vintage Kit Kitridge doll without any changes and the 1804 dress goes over it also without any changes.
Our Generation Doll: If you just have an Our Generation Doll you can make a permanent change to the back facing by folding it in 1" and trimming it back to 1/2" when you hem the raw edge.
Both AGD and OGD: If you want the petticoat or 1804 dress to fit both OGD and AGD you can put a wider velcro patch for the hooks only, then you can pull it across further on the thinner OGD.
Australian Girl Doll: I have tried my AGD petticoat on the Australian Girl Doll and even though I haven't included fitting for the Australian Girl Doll you should be able to make a lovely petticoat for her by just adding 3/4" to the bottom of the main pieces and the side skirts so it is longer. This will make it about 1/2" shorter than the 2004 dress pattern. I will probably do up pattern pieces with the extra length soon so if you want Australian Girl pattern pieces you can convo me through your receipt or email valspierssews at gmail dot com with an image of the title page for the free version. Just give a a week or two to sew up one first.
As with nearly all my garments I have used velcro patches for closure. They don'y get in such a muddle as the long strips do yet they seam to hold just as well for dressing. I have used my coloured velcro that I got from Allie Express. I cut off a piece just wide enough to fit on the facing.
I hope you enjoy this design. I have a dress or two planned using the same flat front panel design.
Look out for the petticoats as a collection in 2019. Sign up for my newsletter so you will always be kept up to date.
This petticoat is the second in a series of 5 that I am giving away for free in my newsletter.
Happy Sewing and Dress Making
Val
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.